1973 Kawasaki Z1 in Crewe, VA

1973 Kawasaki Z1

The bike has been fully restored and has been sitting in my dining area for 2 plus years now. The motor has less than 25 miles on it and was completely rebuilt and I used new old stock oem parts where ever possible. The engine was completely taken down and inspected and has 2nd overbore oem pistons and rings, new cam chain, new guides, new clutch plates, new ape valve guides and seals, new end cam plugs and a complete Vesrah gasket set. It has the original early carbs that are the cleanest rust free set I have ever seen! It has the early head with the blocks located on the lower sides of the intakes and the correct cylinder that takes the one piece gasket.The bike runs great and I will clean the carbs prior to selling if it meets the reserve since it has been sitting. The original early gauges have been restored with 0 miles on them. Has the original handle bar switch blocks coded 2-8 and 2-9. The clutch and brake levers still retain the original plastic covering. I did convert it to a dual disk front end with the correct 5/8 master cylinder and a right side rotor and caliper dated correct for a 73. Left side rotor is stamped 7s and right side is stamped 8c. I do still have the early master cylinder that is stamped with the #2 inside that goes with the bike.It does have the original brake bar and non stamped swing arm as the early bikes were. Original wheels coded 2k303 sti...

Contact Seller:
By clicking here you have given permission for Showme to transmit you information to seller/partner and for Showme and/or seller/partner to contact you.

Check these out: